Remove the property that needs the missing property.Problem: A defined property needs another property that is missing. “ConfigurationDataUrlSasToken requires that configurationData.url is specified” “ConfigurationUrlSasToken requires that configuration.url is specified” “Configuration.url requires that configuration.function is specified” “Configuration.script requires that configuration.url is specified” 'Inconsistent units for width and height in tag 'amp-img - width is specified in 'px' whereas height is specified in 'rem'.' Templating errors AMP pages can't include templating syntax, unless that syntax is within an AMP tag specifically designed to include templates, for example, amp-mustache. “Configuration.url requires that configuration.script is specified” Review the ibmdi.log file for the following exception: ': Invalid Oracle URL specified' was thrown while evaluating an expression. “Configuration.function requires that configuration.url or configuration.module is specified”
Solution: Remove one of the duplicate properties. Problem: The ConfigurationArguments in public settings and the ConfigurationArguments in protected settings contain properties with the same name. As a result, you receive the "Could not connect to the endpoint URL" error."forcePullAndApply ": false "downloadMappings ": ’ in both public and protected configurationArguments” If you run a sync command using -region us-west-1 when the VPC endpoint is in a different Region, then the CLI contacts. VPC endpoints for Amazon S3 are Region-specific. If you're using a VPC endpoint for Amazon S3, then verify that the correct Region is set in the AWS CLI config file.The NAT gateway provisions an internet path to reach the Amazon S3 endpoint. Check if there is a network address translation (NAT) gateway associated with the route table of the subnet.If the EC2 instance is in a private subnet: The configuration file must specify the correct AWS Region. If the network ACL restricts access to only a specific region of Amazon S3 IP address ranges, then check the configuration file of the AWS CLI.If the outbound rule is "DENY", then change it to "ALLOW". In the network ACL, check the outbound rule for port 443. Check the network access control list (ACL) of the Amazon VPC that your instance is in.If the EC2 instance is in a public subnet: Applies to: Certain characters have special meanings when used in file names in OneDrive, SharePoint, Windows and macOS, such as '' for wildcards, and '\' in file name paths.
0 kommentar(er)
